How to use Launch pad V and XPROG3 to change Audi MQB gearbox
Description: Here we take DQ200-MQB Gearbox as an example, replace its ECU and finish the settings. Tools Requirement: X-431 PAD V and X-431 G3 Software Requirement: Audi V28.70 and above, IMMO PROGRAM V10.02 and above. A Brief Introduction: There are two kinds of gearbox ECU replacements, and the customer can choose one of them according to the actual situation. l The data of the customer’s original vehicle gearbox ECU is readable. Data is not damaged, and the gearbox can be cloned. In this situation, we just need to back up the original gearbox EEPROM and FLASH, and then restore them into the gearbox ECU for replacement. l The data of the customer’s original vehicle gearbox ECU is unreadable or the data is damaged. In this situation, we need to back up the EEPROM of the ECU for replacement, and then manually input the original CS code or get the original CS code from the original key. Operation Steps: Situation 1: the customer’s original vehicle gearbox data